Genuine Audi A4 Liftgates

Audi A4 Liftgates Parts and Q&A

• Lift Gate
  8E9-827-023-C
  Q: How should the rear liftgates be removed and installed safely on Audi A4?

  A:

  The liftgate is heavy and somewhat awkward to remove and install, so at least two people should perform this procedure. Begin by opening the liftgate and removing the trim panel/grab handle fasteners located at the center of the lower edge. Next, take out the fasteners on both the left and right sides, then carefully pry the lower section of the trim panel from the liftgate, using just enough force to overcome the spring clips, and unclip the upper section from the rear window opening. Disconnect the wiring from the liftgate components, noting the routing and attachment locations of the wires. Mark the relationship between the liftgate and its hinges with a marker. With assistance to support the liftgate, use a small screwdriver to lift the retaining springs at both ends of the support strut, then pry or pull the strut from the ball stud to detach it. Carefully pry off the hinge covers and remove them, then take out the liftgate-to-hinge fasteners and lift the liftgate clear of the vehicle. For installation, reverse the removal steps, ensuring the liftgate is correctly aligned before fully tightening the hinge bolts. The latch assembly can be adjusted up-and-down after loosening the nuts, and the closed position of the liftgate can be modified by altering the positions of the rubber liftgate stops at the top of the opening. Unclip the plastic cover from the liftgate stop and adjust the center screw in or out as necessary.