To remove halogen bulbs in vehicles manufactured 10/2004 and older, firstly, remove the
Headlight housing and disconnect the electrical connectors on the bulb. The second step is to remove the outer (low beam) or inner (high beam) bulb holder out of the back of the headlight housing and remove the old bulb out of the holder. Only use gloves or a clean rag when dealing with the new bulb after which one can slot the new bulb into the holder. Install the housing again following the same process of removing. Models constructed 11/2004 and up To gain access to the headlight assembly, initially remove any obstructing engine compartment covers or air ducts of the air intake to access the headlight assembly. the plastic cover at the back of the housing, in the case of a low-beam bulb, press the locking tab and slide the cover back, and in the case of a high-beam bulb, press the lock spring over and open the cover. To remove the bulb, unscrew the electrical connector followed by pushing the spring retention clips at the center towards the top and then deleting the spring. Unscrew the bulb directly out of the socket being careful not to touch the new bulb with your fingers. Lastly, install the software again by following the reverse sequence.